| 详细介绍：
M双面胶带 F9473PC 0.25mm*33m
以mm宽度计价
3VHB™ Adhesive Transfer Tapes
with Adhesive 100MP F9473PC
3M™ VHB™ Adhesive Transfer Tapes F9460PC, F9469PC and F9473PC utilize the
high performance of 3M™ Adhesive 100MP, which has excellent long term holding
power with much higher adhesion strength than typical pressure sensitive adhesive
systems. These VHB adhesive transfer tapes are transparent and are ideal for use in
many interior and exterior industrial applications to replace rivets, spot welds, liquid
adhesives, and other permanent fasteners.
Dynamic Mechanical Properties
Note: The following technical information and data should be considered representative or
typical only, and should not be used for specification purposes.
For engineers who have to use adhesive properties for modeling and analysis purpose, we
suggest a Young’s modulus of 4.5 x 102 kPA (measured at 23°C & 1 Hz) and a Poisson’s
ratio of 0.499. For detailed adhesive modulus and damping properties, please refer to the
nomograph for 3M™ VHB™ Adhesive Transfer Tapes, which is available upon request
through our technical service group. The nomograph presents adhesive modulus and
damping properties as functions of temperature and frequency.
Application Techniques Bond strength is dependent upon the amount of adhesive-to-surface contact developed.
Firm application pressure helps develop better adhesive contact and improve bond strength.
To obtain optimum adhesion, the bonding surfaces must be clean, dry, and well unified.
Some typical surface cleaning solvents are isopropyl alcohol/water mixture or heptane.*
Ideal tape application temperature range is 70°F to 100°F (21°C to 38°C). Initial tape
application to surfaces at temperatures below 50°F (10°C) is not recommended because
the adhesive becomes too firm to adhere readily. However, once properly applied, low
temperature holding is generally satisfactory.
深圳君达电子 0755-86173511
宋小姐13923720372 www.kingdays.com
| 
放大图片
暂无相关下载
